Remote Commander - Sony VPL-S500U Mode D'emploi

Remote Commander

The Remote Commander may be used as a wireless or
wired Remote Commander.
For details on operation of the keys not mentioned
here, see the description in the control panel section.
8
7
6
5
1 POWER key
2 VOLUME +/– keys
3 MENU key
4 Joy stick
Used to move the on-screen cursor or to make various
adjustments.
5 ENTER keys
6 RESET key
7 INPUT key
8 MUTING PIC/AUDIO keys
The MUTING PIC key has the same function as the
MUTING PICTURE key on the control panel.
9 !º
POWER
1
MUTING
PIC
AUDIO
INPUT
2
RESET VOLUME
3
4
T
Front
If you connect the mouse receiver to a computer, you
can use the Remote Commander as a mouse for a
connected computer.
For details, see "Operating a Computer from the Remote
Commander" on page 15 (EN).
5
Rear
9 CONTROL S OUT jack (stereo minijack)
Connect to the CONTROL S IN jack on the projector
when using the Remote Commander as a wired
Remote Commander. When using the Remote
Commander as a wired Remote Commander by
connecting a stereo remote commander cable, you do
not need to install the batteries since the power is
supplied from the CONTROL S IN jack on the
projector.
0 Infrared transmitter
!¡ MOUSE/MENU switch
Normally, set to MENU.
Set to MOUSE when you operate the mouse on a
computer connected to the mouse receiver from the
Remote Commander.
For details, see "Operating a Computer from the Remote
Commander" on page 15 (EN).
!¡
Side
11
(EN)