SEVERIN Fino Latte KA4565 Mode D'emploi page 37

Fault
The brewing unit cannot be
closed.
The display element
Preparation is flashing
during preparation process.
The beverage quantity is too
high or too low.
The quality of the milk froth
has deteriorated.
After the heat-up phase (cup
is flashing) the appliance
switches off without
performing the brewing
process.
The heat-up phase takes
very long.
Cause
The strainer support was not closed
correctly or was not appropriately
assembled into the brewing unit and got
entangled.
Appliance requires descaling.
The beverage quantity was not set
appropriately.
The water reservoir does not contain
sufficient water for preparation of a large
beverage quantity.
The respective strainer support is
clogged.
The strainer support for milk froth needs
intensive cleaning.
The valve has not been opened
appropriately.
The respective strainer support is
clogged.
Technical fault
The appliance has become very hot and
must cool.
Remedy
Fold the bracket closure (B) upwards,
remove the strainer support (C or
D), check for faults/irregularities and
reassemble.
Descale the appliance according
to section "5. Cleaning, care and
maintenance".
Set the desired beverage quantity
according to section "3. Preparation of
beverages".
Please fill the water reservoir (L)
appropriately and assemble.
Clean the respective
strainer support according to section
"5. Cleaning, care and maintenance".
Clean the strainer support according
to section "5. Cleaning, care and
maintenance".
The nose at the milk pipe (D.1) must
fit with the nose at the valve (D.2),
otherwise the valve (D.2) will not open.
Clean the respective
strainer support according to section
"5. Cleaning, care and
maintenance".
Contact your competent customer
support desk.
Please wait until the brewing process is
started. If applicable, leave the appliance
to cool for a few minutes.
EN
37