Initial Start-Up - SEVERIN Fino Latte KA4565 Mode D'emploi

2. Initial start-up

Before initial use the following advice list must be observed:
– Rinse all strainer supports with running warm water.
– Plug in the connection line with mains plug (K) to the mains supply.
– Remove the water reservoir (L) and rinse thoroughly with water and fill
with fresh, cold water up to the mark MAX (approx. 900 ml).
– Place the water reservoir (L) straight onto its support and press it
downwards completely so that the valve in the bottom of the reservoir
is opened.
– Place a cup with a minimum capacity of 150 ml onto the drainage
grille (G).
1. Open brewing unit (A). For this purpose, fully fold the bracket closure (B)
upwards.
2. Then take the strainer support for coffee pads (C) and place it into the
brewing unit.
3. Then close the brewing unit (A) by firmly pressing the bracket closure (B)
downwards.
4. Now press shortly the Start/Stop button (H.3)
(H.1) is flashing. After a short heat-up phase the cleaning process is
started and the cup is filled with water.
Important: After the display element (H.1)
an acoustic signal has been emitted the cup must be emptied and step 4
must be repeated. Then, the appliance is ready for operation.
. The display element
has extinguished and
25
EN