Safety Information - SEVERIN Fino Latte KA4565 Mode D'emploi

1. Safety information

Risk of electric shock!
Before every start-up, the entire appliance including all accessories
must be inspected for defects that might impair functional safety of the
device. In the event that the appliance has, for instance, been dropped
onto a hard surface, damage might have occurred that is not visible
from the outside. In such a case the appliance must not be used.
– Inspect the connection line (K) for damage on a regular basis. In case of
existing damage the appliance must not be used any longer.
Important: Please disconnect the appliance from the mains supply
if it is not in use, in case of faults during operation and before every
cleaning process.
– Do not disconnect the appliance from the mains supply by pulling the
cable; but by grasping the plug.
– Please ensure that both the housing and the connection line are
not placed in close proximity of a hot plate or open fire. The same is
applicable for liquids and humidity.
– Repairs and maintenance operations at electric appliances must be
carried out by qualified personnel in order to prevent any risks for health
and safety and in order to comply with safety regulations. The same is
applicable for replacement of the connection line. For this reason, in
case of repair send the appliance to our customer service department.
The address list is enclosed in the section "Customer service" on the last
pages of this instructions document.
Danger of scalding!
Do not touch any hot parts during and after the brewing process or
during the frothing of the milk. The brewing unit (A), the strainer
support (C or D) and the coffee pads are hot. During the frothing of the
milk hot steam comes out. Please note that the prepared beverages are
also very hot.
– Do not open the bracket closure (B) as long as the pump is still in
operation and the brewing process is not completed, since the
appliance is under pressure. After the brewing process, please wait until
the display elements (H.1 and H.2) stop flashing and an acoustic signal is
generated.
– For reasons of hygiene, completely remove the respective strainer
support (C or D) with its contents after every brewing process. Leave the
bracket closure (B) open.
EN
23