Dru DIABLO Instructions De Montage page 3

All manuals and user guides at all-guides.com
Before commencing conversion:
Remove the casing and the
rosette
- Remove the back of the rosette from
the top of the casing.
- Remove the casing and put it in a
safe place to avoid it getting
damaged.
- Remove the outlet pipe from the fire
and put that in a safe place as well.
- Dismantle the front of the rosette
on the top of the casing by removing
the two screws on the inside.
The wall duct, which fits round the
outlet pipe of the fire fairly tightly,
must be mounted vertically.
ASSEMBLY INSTRUCTIONS
1. Wall plate
The wall plate should be fitted to
the wall vertically, above the centre
of the fire (see figs. 1 and 2). Mark
the holes as required, and use the
right-sized drill to fit the plugs.
Mount the wall plate using the
screws provided.
2. Ceiling plate
See fig. 3. Mark the two holes on
the ceiling as illustrated in fig. 4.
Hang the ceiling plate in the wall
duct and fit both to the wall plate.
Pull the ceiling plate up vertically to
the ceiling. Check that the holes
marked and the holes in the plate
correspond.
The ceiling plate has two spacing
SIEROMKADERING AFVOERPIJP DIABLO / DECORATIVE EDGING OUTLET PIPE / CADRE DÉCORATIF DU TUYAU D'ÉVACUATION
ASSEMBLY-INSTRUCTIONS
tabs on either side to centre it in
the wall duct.Take the wall duct
away again and put it to one side.
Drill the mounting holes with a
suitable drill.
3. Mounting
Fit the outlet pipe into the fire.
Check the pipe seals and replace
any damaged sealing rings.
Now mount the ceiling plate using
the plugs and screws provided.
Fit the casing and then hang the
wall duct onto the wall plate.
4. Mantelpiece
The mantelpiece (A in fig. 5) goes
in the same place as the
decorative ring.
Do not screw the mantelpiece
in place; simply lay it on top of the
casing.This will prevent the
decorative edging from getting
damaged should the casing need
to be removed.
3