KERN and SOHN MCB Serie Mode D'emploi page 55

9.4.1 Levelliing
•
The wheel height has to be adjusted for levelling.
•
Levelling is restricted to specialist staff possessing well acquainted
with the workings of weighing scales.

Place scales on an even surface.

Arrest the brake
 Turn the wheel (1) clockwise until the air bubble of the water balance
is in the prescribed circle
Screw counternut (2) upwards till to the stop and it with a suitable
tool (e.g. pliers).
Gap width must not exceed 15 mm!
MCB_MPT-BAPS-e-1912 13