Publicité
Les langues disponibles
Les langues disponibles
in the warnings have been met (par. #2).
7.
The thermometer appears blocked, for instance, some lights remain on for longer
than 2 minutes: reset the thermometer by removing and reinserting the batteries.
11. REPLACING the BATTERIES
• Set your thumb in the oval hollow on the
11
Fig.
back of the unit, press down and slide the
Open
battery hatch out as shown in fig. 11.
• Remove the battery hatch.
• Remove the old batteries and dispose of
them as required in the containers provided
for this purpose.
Close
• Insert 4 new AAA - LR03 batteries, preferably
alkaline, carefully complying with the position indicated in their housing.
• To close the hatch, slide it in the opposite direction from which it was opened.
After changing the batteries, let the thermometer stabilize for 20 minutes before
taking a temperature reading, or run a manual quick calibration (MQCS, par. #8).
• Remove the batteries if you do not expect to use the thermometer for a long
time.
12. CLEANING
CLEANING THE WAVEGUIDE: the thermometer waveguide (fig. 1) is very delicate.
Therefore, when the thermometer is not being used, we recommend that you
always keep the cap on. However, if you need to remove dust or dirt from the
waveguide or sensor at its base, use a cotton swab that has been slightly
dampened with alcohol.
Remove all dirt and make certain that nothing accumulates at the bottom of the
waveguide where the sensor is located.
Do not use any other objects or liquids as the surface of the sensor could easily
be scratched or damaged. Never let any excess liquid penetrate into the
waveguide and sensor.
CLEANING THE THERMOMETER BODY: use a soft cloth dampened with soap
and water and possibly re-wipe with a sodium hypochlorite disinfectant.
DO NOT USE the thermometer for at least 30 minutes after cleaning.
13 - English -
Publicité
