Publicité
Les langues disponibles
Les langues disponibles
Switching on and off
Short-Time Operation
Switching-on:
press the on/off switch
Switching-off:
release the on/off switch
Permanent Operation
Switching-on:
press the on/off switch and, keeping it pressed, engage
the lock button
Switching-off:
press the on/off switch and let release it again
Instructions for Use
Setting the Beveling Depth:
Loosen both wing nuts (A) to set the desired beveling depth. Slide the plate
upwards to increase the bevel and down to decrease it. Tighten the wing
nuts again firmly. Check the beveling depth by making a test cut.
A
Place the pipe cutting system (1) on a flat surface.
The integrated pipe tray (2) can be mounted on the left or right side of the
cutting system, as required. Extend the integrated pipe support (2) to the
desired length.
To cut longer tubes, use the additional tube tray (3).
It must be aligned with the separation system. If necessary, use a tool for
this purpose (slat, straightedge...).
We recommend bolting the pipe cutting system to a pallet.
19
+
-
Publicité
