EIBENSTOCK ERC 350 Notice Originale page 19

Cutting discs flanges and other accessories must properly fit on the

spindle of the power tool. Do not use any reducing pieces or adapters.
Check the accessories before use. Do not use any products which are

broken, cracked or damaged in another way.
Before use, make sure that the tool is correctly fixed and fastened. Let

it run idle for about 30 seconds in a safe position. If considerable
vibrations occur or if other defects are recognised, switch off
immediately.
Always lead the mains and extension cable as well as the extraction

hose to the back away from the machine.
Make sure the wheel is not contacting the workpiece before the switch

is turned on.
Wait until the wheel attains full speed before cutting.

Attention! The tool still runs for a little while after the machine was

switched off.
Before setting the tool down after completing a cut, be sure that the

wheel has come to a complete stop before removing the pipe.
Do not stop the wheel by lateral pressure on the disc.

Never carry the machine at its cable.

Do not touch rotating parts.

Persons under 16 years of age are not allowed to use the tool.

During use, the operator and other persons standing nearly have

to wear suitable ear protectors, a dust mask, protection goggles
as well as protective gloves.
Make sure that persons in the work space are not endangered by

particles flying around.
Keep the handles dry, clean and free of oil and grease.

Power tools have to be inspected by a specialist in regular intervals.

Make sure that the pipe to be cut is empty.

Make sure that the pipe is placed correctly and straight.

For further safety instructions, please refer to the enclosure!
The ERC 350 is made in protection class II.
First, check the correspondence between voltage and frequency against the
data mentioned on the identification plate.
Voltage differences of +6 % to -10 % are allowed.
Only use extension cables with a sufficient cross section. A cross section
which is too small could cause a considerable drop in performance and an
overheating of machine and cable.
Electrical Connection
18