EIBENSTOCK ERC 350 Notice Originale page 18

Safety Instructions
Safe work with the machine is only possible if you read this
operating
instructions contained strictly.
Additionally, the general safety instructions of the leaflet
supplied with the tool must be observed. Prior to the first
use, the user should absolve a practical training. Save all
warnings and instructions for future reference.
Work concentrated and carefully. Keep your work place clean
and avoid dangerous situations.
In order to protect the user, take precautions.
If the mains cable gets damaged or cut during the use, do not
touch it, but instantly pull the plug out of the socket. Never use
the tool with damaged mains cable.
The tool must neither be wet nor used in humid environment.
Do not use the tool in an environment with danger of explosion.

Do not cut into asbestos-containing materials.

Modifications of the tool are prohibited.

Always check the tool, cable and plug before use and plug before use.

Have damages only repaired by specialists.
Insert the plug into the socket only when the tool switch is off.
When you work outside, the machine has to be used with a fault-current

circuit breaker with max. 30 mA.
The machine should only work under supervision of somebody. Plug

and switch the machine off if it is not under supervision, in case of
putting up and stripping down the machine, in case of voltage drop or
when fixing or mounting an accessory.
Switch the machine off if it stops for whatever reason. You avoid that it

starts suddenly and not under supervision.
Don't use the machine if a part of the housing is damaged or in case of

damages on the switch, the cable or plug.
Pay attention that the speed indicated on the cutting disc meets or

is higher than the max. speed indicated on the machine.
Use only diamond cutting wheels for your power tool.

Wheels must be used only for recommended applications. For

example: do not grind with the side of cutting wheel.
Cutting wheels have to be stored and used carefully according to the

instructions of the producer.
instruction completely
17
and follow the