Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Range Hood Controls
Operating the light
1. Move the light switch to the "1" position to turn range hood
lights ON.
2. Move the light switch to the "0" position to turn range hood
lights OFF.
Operating the blower
1. Move the blower switch to the "1" position to turn the blower
ON. The blower will begin operating at the speed set on the
blower speed switch.
2. Move the blower switch to the "0" position to turn the blower
OFF.
Adjusting the blower
The blower has 3 speed controls. Move the blower speed switch
to "1" position for low speed, "2" position for medium speed or
"3" position for high speed.
Range Hood Care
Range Hood Lamps
The range hood uses 12-volt 20-watt halogen lamps. Before you
begin, make sure that the range hood is turned off and that the
other lamps have had sufficient time to cool.
Replace lamp using a tissue to handle the lamp or wear cotton
gloves. Do not touch the lamp with bare fingers.
If new lights do not operate, make sure the lamps are inserted
correctly before calling service.
To Replace:
1. Disconnect power.
2. Turn light switch to off.
3. Gently pull the lamp from the socket clips.
4. Insert the new lamp into the socket clips and gently push the
lamp until firmly in place.
5. Reconnect power
Replacing Hood Lamps Fuse
If all the lights do not light when the light switch is turned on,
check that the fuse is good.
1. Disconnect power at the circuit breaker of fused circuit box.
10
2. Locate the fuse holder assembly next to the terminal box.
A. Terminal box
B. Fuse holder assembly
C. Screws
3. Remove the 2 screws from the cover.
4. Pull the cover back to gain access to the fuse holder.
A. Fuse cover
B. Fuse
C. Fuse holder
5. Push down and twist to remove the fuse cover.
6. Replace the fuse with a new 5 amp time-delay fuse.
7. Replace the fuse cover.
8. Replace the fuse holder assembly cover with the 2 screws
removed earlier.
9. Reconnect power at the circuit breaker of fused circuit box.
Exterior surfaces:
Do not use steel wool or soap-filled scouring pads. Rub in
direction of the grain line to avoid scratching the surface.
Always wipe dry to avoid water marks.
KitchenAid
®
Professional Formula Stainless Steel Cleaner &
Polish is the cleaner recommended for cleaning stainless steel
surfaces on this product. To order call our Customer Service
Center at 1-800-442-9991 or order on-line at
www.applianceaccessories.com and ask for part number
4396920. To order from Canada, call 1-800-807-6777
Mild liquid detergent and water.
Wipe with damp soft cloth or nonabrasive sponge, then rinse
with clean water and wipe dry.
Metal Filters
Use 2 hands to remove filters. Push tab back to release locking
pin, pull down and forward. Repeat with other filter.
Wash metal filters as needed in dishwasher or hot detergent
solution to clean.
A
B
C
B
C
Cleaning
A
Publicité
Table des Matières
