Throttle Tension Adjustment; Idle Speed Adjustment; Motor Cover Fastening Adjustment - Suzuki Df200 Manuel Du Propriétaire

2. If the boat tends to veer to port, move the
rear end of the trim tab toward the port side.
If the boat tends to veer to starboard, move
the rear end of the trim tab toward the star-
board side.
3. Tighten the bolt that holds the trim tab in
place.
After adjusting the trim tab, check to see if the
boat still tends to veer to one side. If necessary,
readjust the trim tab.

THROTTLE TENSION ADJUSTMENT

The tension of the remote control handle can be
adjusted according to your preference. To
increase the tension, turn the adjuster A clock-
wise. To decrease the tension, turn the adjuster
counterclockwise.
Side mount
type
NOTE:
Top mount type
When adjusting the tension of the remote con-
trol handle, consult your authorized Suzuki
Marine Dealer.
16

IDLE SPEED ADJUSTMENT

The idle speed has been factory adjusted
between 600 – 700 r/min. in neutral.
NOTE:
If idle speed cannot be set within the specified
range, contact your authorized Suzuki Marine
Dealer.
MOTOR COVER FASTENING ADJUST-
MENT
If you feel motor cover fastening is loose or too
tight when locking the levers, adjust as follows:
1. Loosen the bolts 1, 2 and 3.
2. Adjust the position of brackets 4, 5 and 6.
To increase the fastening, move the brackets
to the direction A. To decrease the fasten-
ing, move the brackets to the direction B.
3. Tighten the bolts.
Motor cover