Husqvarna 536LiHE3 Manuel D'utilisation page 19

Troubleshooting schedule
Control Panel
Troubleshooting takes place from the keypad.
LED display
Green activate LED flashing.
Error LED flashes.
The machine does not start
Error LED is lit with red light.
Troubleshooting the battery and/or the battery charger during charging.
Battery
LED display
Green activate LED flashing.
Error LED flashing
Error LED is lit
Battery charger
LED display
Error LED flashing
Error LED is lit
MAINTENANCE
Possible faults
Low battery voltage.
Overload.
Temperature deviation.
The power trigger and the activate
button are pressed at the same time.
Dirt in battery connectors.
Service
Possible faults
Low battery voltage.
Temperature deviation.
Over voltage.
Cell difference too much (1V).
Possible faults
Temperature deviation.
Possible action
Charge the battery.
The cutting attachment is jammed.
Release the cutting attachment.
Allow the machine to cool down.
Release the power trigger and the
machine is active.
Clean with compressed air or a soft
brush.
Contact your service agent.
Possible action
Charge the battery.
Use the battery in surroundings
where temperatures are between -10
°C (14 °F) and 40 °C (104 °F).
Check that the mains voltage
corresponds with that stated on the
rating plate on the machine.
Remove the battery from the battery
charger.
Contact your service agent.
Possible action
Use the battery charger only when the
surrounding temperature is between 5
°C (41 °F) and 40 °C (104 °F).
Contact your service agent.
English – 19