Husqvarna 536LiHE3 Manuel D'utilisation page 16

• Use the harness to support the weight of the machine
and make it easier to handle.
WARNING! Watch out for thrown objects.
!
Always wear approved eye protection.
Never lean over the cutting attachment
guard. Stones, rubbish, etc. can be
thrown up into the eyes causing
blindness or serious injury.
Keep unauthorized persons at a
distance. Children, animals, onlookers
and helpers should be kept outside the
safety zone of 15 m. (50 ft.) Stop the
machine immediately if anyone
approaches. Never swing the machine
around without first checking behind you
to make sure no-one is within the safety
zone.
• Always use both hands to hold the machine. Hold the
machine at the side of your body.
• Make sure that no clothes or parts of the body come
in contact with the cutting equipment when it is
activated.
• When the motor is switched off, keep your hands and
feet away from the cutting attachment until it has
stopped completely.
• Watch out for stumps of branches that can be thrown
out during cutting. Do not cut too close to the ground.
Stones and other objects can be thrown out.
• Check the working area for foreign objects such as
electricity cables and animals, etc, or other objects
that could damage the cutting attachment, such as
metal items.
• If anything jams in the blades while you are working,
switch off the engine and wait until it has stopped
completely before cleaning the blades. Disconnect the
battery.
• Never leave the machine unsupervised with the motor
running.
16 – English
WORKING TECHNIQUES
Safety instructions after completing work
Li-ion Li-ion
• The transport guard should always be fitted to the
cutting attachment when the machine is not in use.
• Make sure the cutting attachment has stopped before
cleaning, carrying out repairs or an inspection.
Disconnect the battery.
• Always wear heavy-duty gloves when repairing the
cutting attachment. The blades are very sharp and
can easily cause cuts.
• Store the machine out of reach of children.
Basic working techniques
• Work with a swinging action from the bottom upwards
when trimming sides.
• When trimming a hedge the motor should always face
away from the hedge.
• Hold the machine as close to your body as possible to
get the best balance.
• Make sure that the tip does not touch the ground.
• Do not rush the work, but work steadily until all the
branches have been cut back cleanly.