Operation; Operation Instructions - Zipper Maschinen ZI-BTM160 Manuel D'utilisation

12

OPERATION

Device to be operated in a perfect state only. Inspect the device visually every time it is to be used.
Check in particular the safety equipment, electrical controls, electric cables and screwed connection for
damage and if tightened properly. Replace any damaged parts before operating the device.

Operation instructions

Perform all machine settings with the machine being disconnected
 Install and operate the concrete mixer on a solid and flat surface
(making sure it does not fall over).
 Keep the working area clear by tripping hazards.
 It should be possible to swivel the drum to the right and left. There must
be sufficient space for a wheelbarrow under the drum, so that it can be
emptied.
 The mixer drum to be only filled and emptied when the engine is
running.
 Pay attention to the rotation direction of the mixer drum.
Do not move the concrete mixer during operation!

Regularly check the contact pressure of the swiveling wheel. If it were

necessary, re-tighten the tension spring.
Operation
Switch On-Off:
Plug the machine into a socket.
Push „I" (green button) to switch on
Push „0" (red button ) to switch off
Swiveling the drum:
The tipping wheel provides an easy positive
control of the drum which can be locked in the
mix, discharge and storage position.
The drum is locked in the position by a self-
locating plunger which engages into the tipping
wheel. To tilt the drum, the locking plunger
must be dis-engaged by pressing down the foot
pedal. This allows the tipping wheel and drum to
be turned in the same direction. To retain the
drum in position, aligning the slot with the
plunger, release the foot pedal and rotate the
tipping wheel until the self-locating locking
plunger engages into the tipping wheel.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-BTM160 ZI-BTM180
WARNUNG
from the power supply!
HINWEIS
OPERATION
28