Checking The Fuel Tank Level; Operation - Zipper Maschinen ZI-RPE120GYN Mode D'emploi

15.2.2 Checking the fuel tank level

Observe the safety regulations for fuel control. Filter the fuel during refuelling to
prevent foreign particles from entering the combustion chamber. Wipe up leaked fuel.
Procedure:
1. Unscrew the tank cap (sits on the fuel tank).
2. Level check in the form of a visual inspection. If necessary, top up with petrol
3. Close the fuel filler cap tightly after refuelling.
16

OPERATION

 Save the working environment before you start compressing.
 Only put the machine into operation after you have read and understood the safety
instructions and carried out the necessary measures before initial commissioning.
 The correct moisture content of the soil is very important for correct compaction.
Compaction of dry materials is facilitated by moistening the material. Too much
moisture leaves behind water-filled cavities which weaken the load-bearing capacity of
the soil.
 Wetness or excessive irrigation can lead to overloading and death of the engine.
ZIPPER MASCHINEN GmbH
ZI-RPE120GYN
with the appropriate octane number (RON 95).
www.Zipper-Maschinen.at
1. To check the engine oil level, place the machine on
a safe, level surface. Switch off the engine and
allow the machine to stand for ten minutes so that
the circulating oil can collect in the oil pan.
2. Unscrew the oil dipstick and wipe with a clean,
lint-free cloth or a non-fibrous paper towel.
3. Push the measuring rod back into the opening as
far as it will go, but do not screw it in. (Make sure
that the rod has really been pushed in completely
- sometimes it cants itself).
4. Pull out the oil dipstick again and read off the oil
level. There are two markings for this - see
illustration on the left.
5. If the oil level is low, refill recommended oil up to
the upper edge (maximum filling volume: approx.
0.5 litres).
6. Insert the oil dipstick again and tighten.
N O T I C E
28