Measures Before Each Use; Checking The Engine Oil Level - Zipper Maschinen ZI-RPE120GYN Mode D'emploi

The machine is supplied pre-assembled. The parts that have been dismantled to facilitate
transport must be assembled before start-up/use.
Procedure:

15.2 Measures before each use

The use of paint thinners, petrol, aggressive chemicals or abrasives leads to material damage
to the surfaces! Therefore use only mild detergents for cleaning!
Observe the safety instructions (at the beginning of this manual).

Clean the machine and remove dirt and dust if necessary.

If the air filter is dirty, blow the filter cartridge from the inside by moving a jet of dry

compressed air up and down. Continue until all dust has been removed. Replace the
air filter with a new one if necessary.
Check the carburettor for external dirt and dust and clean it with dry compressed air if

necessary.
Check the nuts and bolts for tightness. (Screws or bolts loosened by vibrations can

lead to accidents!)

15.2.1 Checking the Engine Oil Level

Too low an oil level will damage the engine and shorten the service life of your machine.
Therefore, check the engine oil level before each start and top up if necessary.
ZIPPER MASCHINEN GmbH
ZI-RPE120GYN
www.Zipper-Maschinen.at
1. Fasten holding bracket to the base frame using screws,
washers and snap rings (see illustration on the left).
2. Mount throttle lever to the holding bracket (see picture
on the left).
3. If desired, fix the rubber mat to the underside of the
machine using the metal strips and screws also
supplied, and fit the transport device (see illustration
on the left).
N O T I C E
N O T I C E
27