Tosima W3 Manuel De L'utilisateur page 16

TROUBLESHOOTING
When the error indicator is flashing red with continuous and short
sounds, please inspect if:
The plug of the power cord is loosened or damaged and results in power off or
poor contact.
The glass or mop is too wet and results in too low friction.
The glass has impurities attached and results in too high friction.
The mop holder is incorrectly installed and results in air leakage.
The glass surface has sticky objects causing too much friction on the wipe
The suction port is blocked.
The error indicator is flashing red and green alternately with alarming
sound. It means trouble occurs on the inside hardware of the robot,
please contact the customer service directly.
On the condition of special glass, when cleaning the bottom of glass,
it needs more time for cleaning up, please use remote control.
In the case of the robot can't walk freely, please change the mop or
inspect the screws on the cleaning roller, ensure they are not loosened.
If the robot mop holder shakes too strong when the robot is working,
please check if the wipe cloth is too wet, and replace with a dry cloth.
There will be a little delayed water spraying when the robot start to
work, this is a normal phenomenon.
"Di Di Di Di Di" 5 alarms every 5 seconds interval, when there is a
shortage of solution.
After cleaning, there's residual round marks on the glass surface,
please change a new mop.
After completing the whole process of cleaning, the robot continues
to move and doesn't stop automatically, press the Pause Button and
take it down.
When it is in use, maybe bug occurs occasionally, please restart the
robot as the solution.
If there is a downward sliding when the robot is working, please
inspect if:
The cloth is too wet or too dirty.
The robot cannot resume work after a while, replace it with a dry and clean wipe cloth.
The cloth is too dry to cause slips, turn on the water spray function to moisten the
wipe cloth, then the robot can resume work.
Cause of Air Leakage,please inspect if:
The mop holder is installed correctly.
The wipe cloth installation for flatness.
The surface of the glass or other targeted surface are curved or covered with an
uneven-surfaces such as stickers.
The robot goes to the window frame, the mop holder will be warped to produce a
wide range of air leakage.
16 ENGLISH