Tosima W3 Manuel De L'utilisateur page 10

Safety Rope
Check whether the safety rope is intact and is on a stable object.
Working Environment Inspection
Ensure the glass surface is dry, please do not use it when it is raining or when the
glass surface is foggy.
Do not use on broken and cracked glass.
If outside working at height is required, ground safety warnings must be set up to
prevent accidental personal injury.
The robot cannot be used when there are stickers or oil on the glass surface, to
avoid robot slipping and falling from glass.
Wet and Dry Wipe
If there are sand and dust on the glass surface, it is recommended to clean it manually
first to avoid scratching the glass when the robot is working. If manual cleaning is
not possible, it is recommended to turn off the water spray function and use dry mops
to wipe off the sand and dust first.
If there are only dirt stains, it can be wiped directly with the water spray (default turn
on water spray).
If there is slipping and twisting when the robot climbing, please install a dry wipe and
turn on the water spray.
If there are small areas of stubborn stains, you can use "spot cleaning" and turn on
the water spray.
If the robot has serious shaking or rattling, please install a dry wipe cloth.
Start
Ensure the power cord and plug are completely connected.
Long press the Start /Power button (more than 3 seconds) the robot will turn on.
After the fan is running, attach the robot on the glass to a location far away from the
window frame.
Ensure the robot has been stuck to the glass and then let go.
Short press the power button to start the robot.
Remove Robot from Glass
When the robot is running, hold the safety cable with one hand, short press to stop
the robot and take it down with the other hand.
If you cannot reach the robot, and do not have the remote control on hand, please
stay close to the glass to drag the safety rope, and slowly pull the robot back to the
location reachable by hand, then remove the robot from the glass after powering off.
After completely taking down the robot, long-press the power button (more than 3
seconds) to turn it off.
Power Outage Protection
This robot is equipped with an internal battery, which can hold on the robot for twenty
minutes in case the robot is accidentally removed from the power cord and it will raise
an audible and visual alarm. Please take down the robot as soon as possible.
When the light indicator is red before turning on the device, it means the internal battery
is too low to start the robot. Please, keep the robot connected to the electricity to
charge it until the red lamp is off.
10 ENGLISH
INSTRUCTION AND CAUTIONS