Tosai SRE 300 Mode D'emploi page 52

CHILD SAFETY DEVICES
Timer Release
Press <OFF> key.
Timer lamp goes off.
Once the restarting time is programmed, the
heater can be operated thereafter
with following procedure:
1. Press < ON > key.
Operation lamp lits.
*This step is not necessary while the heat-
er is already in operation.
2. Press < TIMER CONTROL > key.
The Unit restarts at the programmed time.
To restart the Unit before the programmed
time, press timer control key.
NOTES:
Blackouts and earthquakes after timer programming:
In case of power failure caused by blackouts, programmed data will be cancelled,
and after power is back, digital indicator will show the current room temperature.
In case of power failure caused by earthquakes, digital indicator will show "E4", and red operation
lamp will flash.
In either case, timer lamp is not on. Press <OFF> key, then follow the procedure for current time
adjustment and timer programming.
CAUTION!:
Be sure to clear all flammable materials around the heater.
CHILD SAFETY DEVICES
Press <CHILD SAFETY> key for 3 seconds.
"Child safety" is indicated with peep sound.
Under <ON> operation:
All functions except extinguishment [ off ] key are re-
stricted.
Under <OFF> operation:
All functions except cancellation of child safety sys-
tem are restricted.
Cancellation of child safety system can be done by
pressing <CHILD SAFETY> key for 3 seconds.
"Child safety" indication goes off.
CAUTION!
If any error code is indicated, cancel the child safety
system and then follow steps and
50
56
57