Tosai SRE 300 Mode D'emploi page 35

SUMMARY OF THE OPERATION
IGNITION – SHUTTING OFF – FASTEN IGNITION
To ignite your heater, press the switch ON, the operation lamp goes red. During ignition (+/- 2
minutes), a calculation will be done from 5 to 1 then the apparatus ignites.
To shut off your heater, press the switch OFF, the operation lamp goes out, the blower fan will remain on for
approximately 3 minutes to cool down your heater.
ADJUSTING THE TEMPERATURE
The preset temperature will be set at 20° C, to raise the temperature, press on + and to lower the temperature,
press on -. You can set the temperature between 2°C and 30°C.
SETTING THE TEMPERATURE – AUTO OPERATION
To use the regulation of you heater, press AUTO switch, the AUTO lamp will come on. You just have to select
the temperature with switch + and –. The heater will not shut off but will adjust his power in function with the
room temperature.
SETTING THE TEMPERATURE – ECO/SAVE OPERATION
To use the thermostat of your heater, press SAVE switch, the SAVE lamp will come on. You just have to select
the shutting off temperature with switch + and -. The heater will shut off 3 to 5°C above the setting temperature
and will re-ignite when the setting temperature is reached.
SETTING THE TEMPERATURE – MODE MIN
To set the maximum power of your heater at 800 Watt (for SRE 300) and 1100 Watt (for SRE 4600), press MIN
switch, the MIN lamp will come on. The heater will work at his minimal power whatever the selected
temperature or that of the room.
SET THE TIME
To set the time, press MODE switch, the clock set lamp is lit, the digitally displayed time is flashing at 00:00 at
time of purchase. Press on switches + and – to set the time. The time setting will be completed after you have
wait for few seconds.
TIMER OPERATION - MODE TIMER
You have first to set the time, then press switch ON (it is not necessary if the heater is working). Press switch
TIMER, the heater will turn off or is not working. The display shows automatically "6:00", you can set the start
time with switches + and – as for the setting off time. Once the start time is selected, wait for a few seconds
and the setting will be completed. The timer operation works only if the TIMER switch is green.
PREVENTING TAMPERING – CHILD SAFETY LOCK
To set the child safety lock, press CHILD SAFETY LOCK switch for more than 3 seconds, the child safety lock
lamp will come on. To cancel, press CHILD SAFETY LOCK switch for more than 3 seconds again and the
operation switch will turn off.
33