Publicité
Les langues disponibles
Les langues disponibles
WARNING
A blade by which the wear limit (marking) has been exceeded can break off and spin away; this can cause severe
injuries.
Replacing the blade
WARNING
The cutting blade bar must always be replaced by an authorised workshop. A wrongly assembled cutting blade
coupling or a blade screw that is tightened too tightly or too loosely can allow the cutting blade bar to become loose
and cause severe injuries.
–
Only use original blades for replacement purposes (Order no. see original spare parts and accessories).
–
Blades must be indelibly marked with name and/or trademark of the manufacturer or supplier and with the parts number.
Servicing the front wheels
Oil the bearings of the wheels once a year or every 50 hours of operation.
–
Remove the wheel cap cover on both sides.
–
Use a socket wrench to loosen the hexagonal nut, remove the washer and take the wheels along with the wheel cap
and the disc from the wheel axle. Remove the wheel cap from the wheel.
–
After greasing the bearing, slide the wheel into place. First insert the disc into the wheel, fit the wheel cap and then push
until you hear a click. Fit the washer, secure with the hexagonal nut and tighten so that the wheel is able to rotate freely
but has no play. Replace the wheel cap cover.
Servicing the rear wheel drive (Illustration R )
Oil the bearings of the wheels once a year or every 50 hours of operation.
–
On both sides, remove the wheel cap cover and the washer and take the drive wheels along with the wheel cap and the
disc from the wheel axle.
–
Remove dirt and greasy residue from the wheel cover, the free-wheel pinion on the gear shaft and the toothed ring on
the inside of the wheel.
NOTE
Do not remove the free wheel pinion from the gear shaft!
–
After greasing the bearing, slide the wheel into place. When fitting the drive wheel, ensure that the pinion and the
toothed ring connect, if necessary turn the wheel slightly on the axle.
–
If the wheel cap has come away from the wheel, first insert the disc into the wheel in accordance with the illustration R ,
replace the wheel cap and press until you hear the click. Fit the washer to the screw and screw both into the wheel axle.
Replace the wheel cap cover.
Servicing the drive
–
It is absolutely essential that the Bowden cable runs easily for switching on and off, so that the control drive works
perfectly.
–
The Bowden traction mechanism has been set ready for operation at the works and requires no adjustment.
Changing the drive V-belt
The drive V-belt must be replaced by a specialist workshop.
Recharging the starter battery (only for electro-start)
IMPORTANT
Use the charger supplied only for charging the respective mower battery. Equally, do not try to charge your mower
using a different charger. You could endanger yourself or damage your equipment.
For safety reasons and to avoid damage to the charger, it may only be used indoors and in dry rooms and the
battery must not be charged in direct sunlight.
The battery can either be charged in the installed position or removed for charging.
–
Separate the connection between the battery cable and the wiring harness.
–
Remove the battery.
To remove the battery, detach the cable from the wiring harness, remove the wing nuts. Turn the battery with the battery
lid by 90° to the front and remove upwards.
–
Connect the battery cable to the original charger and plug the charger into a socket with 230 V. (See also Chapter "Prior
to initial start up – Charging the starter battery")
17
GB
Publicité
