Publicité
Les langues disponibles
Les langues disponibles
Dry the burners completely. If there are water droplets
3.
or damp patches on the cooktop when you start cook-
ing, the enamel may be damaged.
Reassemble the burner parts. Ensure that the burner
4.
caps are correctly positioned on the burner bases.
→ "Burner cap and burner base placement", Page 11
8.3 Cleaning the burner grates
Wait until the appliance has cooled.
1.
8.4 Cleaning recommendations
Follow these cleaning recommendations for the individual parts of your appliance.
Part / Material
Suitable cleaning method
Burner base / alu-
¡ Non-abrasive cleaner: Dish soap and hot
minum alloy
¡ Mild abrasive cleaners: Bon Ami®
Rinse and dry immediately.
Burner cap / porcelain
¡ Non-abrasive cleaners: Dish soap and hot
enamel
¡ Mild abrasive cleaners: Bon Ami®
¡ Liquid cleaners: Soft Scrub®
¡ For food stains: abrasive cleaners such as
Rinse and dry immediately.
Control knobs and
Non-abrasive cleaners: Dish soap and hot wa-
grommets
ter
Dry thoroughly after cleaning.
Exterior finish / stain-
¡ Clean with soapy water and soft cloth, then
less steel
¡ Condition steel with the Bosch Stainless
¡ Hard water spots: Household white vinegar
¡ Mild abrasive cleaners: Kleen King®
¡ Heat discoloration: Bar Keepers Friend®
Rinse and dry immediately.
1
These marks are registered trademarks of their respective owners. All other trademarks are trademarks of BSH Home
Appliances Corporation or its affiliated companies.
water
1
Scrub®
water, ammonia, Fantastic®
1
Comet®
1
Zud®
, Barkeepers Friend®
rinse and dry with a soft cloth.
Steel Conditioner (part # 00576696). Not for
use on black steel.
less steel liquid cleaner, Bon Ami®
Carefully lift off the burner grates.
2.
Scrub with a non-metallic brush and soapy water. Care-
3.
fully clean around the rubber feet. If the rubber feet
come off, the grates may scratch the cooktop surface.
Dry the burners grates completely. If there are water
4.
droplets or damp patches on the cooktop when you
start cooking, the enamel may be damaged.
Place the burner grates in their proper position.
5.
→ "Burner grates", Page 11
Important notes
¡ Do not scratch or gouge the port openings.
¡ Clean ports with a wire or a straightened pa-
1
or Soft
per clip.
¡ Do not use a toothpick, it may break off.
¡ Do not soak burner bases.
¡ A toothbrush can be used for stubborn
stains.
¡ Acidic and sugar-laden spills deteriorate the
1
enamel. Remove soil immediately after the
1
1
, Ajax®
,
appliance has cooled enough to touch.
¡ Do not use wet sponge or towel on hot
1
porcelain.
¡ Do not soak burner caps.
1
¡ Always apply minimal pressure with abrasive
cleaners.
¡ Dry thoroughly and make sure the burner
cap is seated properly on the burner base
after cleaning.
¡ Do not remove the control knobs when
cleaning the appliance. The appliance may
be damaged if moisture finds its way inside.
¡ Do not remove grommets. You will require
Customer Service to refit them. DO NOT
USE THE COOKTOP WITHOUT ALL
PARTS FITTED CORRECTLY!
¡ Do not soak the control knobs or grommets.
¡ Do not clean the control knobs in the dish-
washer, they may be damaged.
¡ Do not use abrasive scrubbers or cleaners,
such as Bon Ami®
They may permanently damage the finish or
remove graphics.
¡ Do not use steel wool pads. They will
scratch the surface.
¡ Stainless steel resists most food stains and
pit marks providing the surface is kept clean
and protected.
¡ Never allow food stains or salt to remain on
1
stainless steel for any length of time
stain-
1
¡ Rub lightly in the direction of the grain.
1
¡ Chlorine or chlorine compounds in some
cleaners are corrosive to stainless steel.
Check the ingredients on the label before
using.
Cleaning and maintenance en-us
1
1
, Ajax®
, or Comet®
1
.
15
Publicité
