Delay/Looper Knob; Reverb Knob - Roland CUBE-80x Guide D'utilisation

DELAY/LOOPER Knob

You can switch to either of two delay
types or the LOOPER function by
positioning this knob.
When the knob is at WARM or CLEAR,
this functions as a delay, and you can
adjust the volume level of the delay by
adjusting the knob's position.
The indicator lights up when delay is on and goes out when it's
off. You can also switch this on and off using an optional
footswitch pedal.
When the knob is positioned at LOOPER, you can use it to adjust
the volume level of playback using the LOOPER function.
This indicator lights up when the LOOPER function is on. The
indicator flashes when a footswitch pedal is used to switch off
(mute) LOOPER.
Knob Position Function
WARM
Delay
CLEAR
LOOPER Looper
* The scale indications for WARM, CLEAR, and LOOPER are just a general
guide. Be sure to check the actual sound as you adjust the effect.
* When the knob is positioned at LOOPER, no delay effect is applied. To
use the LOOPER and delay simultaneously, refer to "Using the LOOPER
Function and Delay at the Same Time" (p. 18).
Description
This is a feedback delay with
a warm analog-delay feel.
Turn the knob clockwise to
increase the effect sound.
This is a delay with one to
two repetitions.
Turn the knob clockwise to
increase the effect sound.
This enables the loop-play
mode.
You can vary the volume
level for playback by
adjusting the position of the
knob. For more information,
refer to "Using the LOOPER"
(p. 17).
TAP Switch
When the knob is positioned at WARM or CLEAR, you can
use this to adjust the delay time.
When the knob is positioned at LOOPER, this switch
controls recording, playback, and overdubbing.
Knob
Function
Position
WARM, Adjusts the
CLEAR delay time
Starts and
stops Looper
LOOPER
recording
and playback

REVERB Knob

You can switch between use of two types of
reverb by changing the position of the knob.
You can adjust the intensity of the effect by
varying the knob position.
The indicator lights up when reverb is on and
goes out when the effect is off. You can also
switch reverb on and off using an optional
footswitch pedal.
Knob Position
This is modeled on spring reverb.
It produces the distinctive
SPRING reverberations of a spring. Turning the
knob clockwise makes the effect
progressively more intense.
This is a plate reverb.
This reverb features high-end sustain.
PLATE
Turning the knob clockwise makes the
effect progressively more intense.
Panel Descriptions
Operation
Delay time of 90 ms or more
Pressing the switch twice sets
a delay time equal to the
interval between presses. You
can set a time of up to 2,000 ms
when the knob is at WARM or
up to 1,000 ms when the knob
is at CLEAR.
Delay time of 90 to 30 ms
Holding down the TAP switch
for one second or longer
changes the delay time in a
stepwise fashion from 30 to 90
ms, according to the number of
seconds you hold the switch
depressed (four stages: 30 ms,
50 ms, 70 ms, and 90 ms).
Refer to "Using the LOOPER
Function and Delay at the Same
Time" (p. 18).
Description
9