Titan 0524033 Notice D'utilisation page 4

Maintenance
Use the following procedures to keep your HVLP spray system
running properly.
Cleaning / Replacing the Filters
IMPORTANT: Make sure the turbine is unplugged before
changing the filters.
1. Remove the filter covers on each side of the turbine by
turning them counterclockwise.
Filter cover
2. Remove each filter set (pre-filter and filter) from the filter
housing on each side of the turbine.
NOTE: The white pleated filter is removed from the
turbine in the same manner as the filter cover. Turn
counterclockwise to unlock and remove.
White pleated filter
Pre-filter
Filter cover
3. Clean the filters. Either tap the filters to knock out the
contaminants or use pressurized air to blow out the
contaminants. For material that is not blown or knocked loose
easily, soak the filters in soapy water or mineral spirits. Allow
the filters to dry completely before placing them back in the
turbine.
NOTE: Do not use highly flammable solvents, such as
lacquer thinner, to clean the filters.
IMPORTANT: Do not soak paper pleated filter in solvents. Only
tap the filter or use compressed air directed at the inside (the
clean side).
English
Filter cover
Pre-filter
Filter
4. Insert each filter back into its corresponding filter can.
NOTE: Make sure the white pleated filter is fitted securely
to the spokes of the filter can. Turn clockwise to
secure in place.
5. Replace the filter covers on each side of the turbine by turning
them clockwise.
After several cleanings, it may become necessary to replace the
filters. Refer to the parts list near the end of this manual for the filter
replacement kit part number.
Cleaning the Air Hoses
1. Periodically wipe the outer surface of the air hose with a damp
cloth to keep clean.
IMPORTANT: DO NOT submerge into or flush the air hose with
water or any chemical.
IMPORTANT: DO NOT use methylethylketon (MEK), naphtha,
mineral spirits, paint thinner, xylol/xylene, or toluel/toluene to
clean the air hose. Exposure over time could cause damage to
the hose.
IMPORTANT: Store indoors with the cord wrapped around the
handle.
4 © Titan Tool Inc. All rights reserved.