Toro Recycler 20367 Manuel De L'utilisateur page 21

Problem
It is difficult to remove the battery pack
from the tool.
The machine is producing a beeping
sound.
The quality of cut is decreased or
unsatisfactory.
The bagging is decreased or
unsatisfactory.
The machine is cutting unevenly.
The machine is vibrating.
Possible Cause
1. The battery pack/tool is new or there
is corrosion in the battery terminals
and/or the terminals on the tool.
1. The battery pack is not charged.
2. The machine is in an unsafe position
for operation.
3. The machine is overloaded.
4. There is another electrical problem
with the machine.
1. The blade is dull.
1. The machine is overloaded
1. The blade is dull.
2. The cutting deck is damaged.
1. The blade is bent or damaged.
19
Corrective Action
1. Clean the terminals on the battery and
the tool. Then apply dielectric grease
to the battery terminals; do not use
any other type of lubricant as it can
damage the terminals.
1. Remove the battery pack from the
machine and charge it.
2. Ensure that the machine is not at an
extreme angle while operating.
3. Cut the grass at a higher height of cut
or walk at a slower pace while mowing.
4. Attempt the other troubleshooting
actions, if the alarm still sounds,
contact an Authorized Service Dealer.
1. Have the blade sharpened or replaced.
1. Cut the grass at a higher height of cut.
1. Have the blade sharpened or replaced.
2. Contact an Authorized Service Dealer.
1. Inspect the blade and replace if
necessary.