Toro Recycler 20367 Manuel De L'utilisateur page 17

1. Remove the electric-start button and battery
from the machine.
2. Ensure that the cutting-height setting on the
machine is 44 mm (1-3/4 inches) or higher; if
it is not, raise it; refer to
Height (page 11).
3. Disengage the handle locks
Figure 15
4. Fold the handle fully forward.
Important:
Route the cables to the outside
of the handle locks as you fold the handle.
5. Engage the handle locks.
6. Lift the front of the machine by the handle and
move it into a storage space
Figure 16
Adjusting the Cutting
(Figure 15).
g297000
(Figure 16).
g297023
15