Machine Stop - Nilfisk SR 1450 B Manuel D'utilisation

ENGLISH
Waste collection (SR 1450 B)
– Check the battery charge indicator (10, Fig. J) to start a working cycle with a charge lower than the 75%.
WARNING!
Do not force the machine when the battery charge is lower than the 50%, excessive electrical inputs may occur,
with consequent cut-off of the power fuse.
– Press the switch (15, Fig. J) to operate the suction fan.
– Skirt opening: push the distributor lever (3, Fig. J).
– If the suction is diffi cult, make sure that the skirt closing panel is completely open.
– To start and lower the main and side broom, push the distributor lever (1, Fig. J).
– To start and lower the main broom only, pull the distributor lever (1, Fig. J).
When necessary, dump the hopper as follows:
WARNING!
Move the machine extremely slowly when the hopper is in the lifted position.
Maximum speed 1 km/h.
Do not dump the hopper with the machine on a slope.
– Lift the main and side brooms by pulling the distributor lever (2, Fig. J).
– Stop the broom rotation by placing the lever (1, Fig. J) to central position.
– Turn of the suction fan by pressing the switch (15, Fig. J) and bring it back to the original position.
– Close the skirt by pulling the distributor lever (3, Fig. J).
– Drive the machine to the appointed dumping area.
WARNING!
When dumping the hopper, make sure that nobody is near the machine.
– Lift the hopper by pushing the distributor lever (2, Fig. J) until the proper height for dumping is reached.
– Open the skirt by pushing the distributor lever (3, Fig. J).
– Lower the hopper by pulling the distributor lever (2, Fig. J).
– Close the skirt by pulling the distributor lever (3, Fig. J).
– Activate the fi lter shaker by pressing the switch (9, Fig. J) for approx. 20 seconds.
WARNING!
Do not activate the fi lter shaker with the hopper in the lifted position.

MACHINE STOP

At the end of the working shift, stop the sweeper in the appointed area with:
– Brooms in the lifted position;
– Hopper in the lowered position;
– Parking brake lever engaged;
– Lights off (if on);
– Engine stopped;
– Ignition key removed.
WARNING!
Never leave the hopper in the lifted position without using the safety props (1, Fig. K).
16
USER MANUAL
33014811(3)2010-03 A SR 1450 B-D