Toro TimeMaster Mode D'emploi page 7

2. Release the handle-lock lever
1. Handle-lock lever
3. Pull the handle rearward and lock it into position
(Figure 4).
2
Filling the Engine with Oil
No Parts Required
Procedure
Important:
Your machine does not come with oil
in the engine, but it does come with a bottle of oil.
Before starting the engine, fill the engine with oil.
Engine Oil Specifications
Engine oil capacity
Oil viscosity
API service classification
1. Move the machine to a level surface.
2. Remove the dipstick by rotating the cap
counterclockwise and pulling it out
All manuals and user guides at all-guides.com
(Figure 4).
Figure 4
0.53 L (18 fl oz)
SAE 30 or SAE 10W-30
detergent oil
SJ or higher
(Figure
1. Full
g016551
2. High
3. Carefully pour about 3/4 of the engine capacity
of oil into the oil-fill tube.
4. Wait 3 minutes for the oil to settle in the engine.
5. Wipe the dipstick clean with a clean cloth.
6. Insert the dipstick into the oil-fill tube, then
remove the dipstick.
7. Read the oil level on the dipstick
•
If the oil level on the dipstick is too low,
carefully pour a small amount of oil into the
oil-fill tube, wait 3 minutes, and repeat steps
5 through
the correct level.
•
If the oil level on the dipstick is too high, drain
the excess oil until the oil on the dipstick is
at the correct level; refer to
Engine Oil (page
Important:
low or too high and you run the engine, you
may damage the engine.
8. Install the dipstick into the oil-fill tube securely.
Important:
Change the engine oil after the first 5
operating hours; change it yearly thereafter. Refer
to Changing the Engine Oil (page
5).
6
Figure 5
3. Low
(Figure
7 until the oil on the dipstick is at
Changing the
20).
If the oil level in the engine is too
20).
g193261
5).