Toro TimeMaster Mode D'emploi page 23

Replacing the Fuse
Electric-Start Model Only
If the battery does not charge or the engine does not
run with the electric starter, the fuse may be blown.
Replace it with a 40 A plug-in type fuse.
Important:
You cannot start the machine with
the electric starter or charge the battery unless a
working fuse is installed.
1. Open the sealed fuse holder and replace the
fuse (Figure 35).
Figure 35
1. Fuse holder
2. Close the cover to the fuse holder, and ensure
that it is sealed tightly.
Replacing the Battery
Electric-start model only
Removing the Old Battery
1. Contact an Authorized Toro Parts Dealer to
obtain a replacement battery.
2. Remove the belt cover; refer to step
Servicing the Blade-Drive System (page
3. Remove the rear-discharge plug.
4. Move the handle to the vertical position.
5. Remove the 4 small bolts that hold the rear door
and handle-lock-lever assembly in place.
6. Fold the handle all the way forward.
7. Remove the rear door and handle-lock lever
assembly (Figure
All manuals and user guides at all-guides.com
1 of
23).
36).
1. Rear door and handle-lock-lever assembly
8. Remove the cover from the battery.
9. Disconnect the leads from the battery.
10. Remove and battery and recycle it.
Note:
Recycle the battery according to your
state and local regulations.
g020856
Installing the New Battery
1. Clean the battery-holding area on the machine
housing.
2. Set the new battery in place on the machine
housing.
3. Connect the leads to the new battery.
Note:
Ensure that you connect the black
(negative) wire to the negative (-) terminal and
the red (positive) wire to the positive (+) terminal.
4. Install the cover onto the battery.
Note:
Ensure that the cover fits properly over
the wire harness.
5. Install the rear door and handle-lock-lever
assembly onto the machine.
6. Raise the handle to the vertical position.
7. Secure the shroud with the 4 small bolts that you
removed in step
(page 22).
8. Install the rear-discharge plug.
9. Return the handle to the operating position.
22
Figure 36
5 of Removing the Old Battery
g017523