Toro TimeMaster Mode D'emploi page 11

Important:
This machine is equipped with
a premium fuel tank that uses a foam insert
to prevent fuel agitation. Never remove the
foam element, because it allows the engine
to use all the fuel in the tank
Figure 12
1. Foam insert
2. Install the fuel-tank cap and tighten it securely
by hand.
All manuals and user guides at all-guides.com
Checking the Engine-Oil
Level
(Figure 12).
g197639
10
1. Move the machine to a level surface.
2. Remove the dipstick by rotating the cap
counterclockwise and pulling it out
Figure 13
1. Full
2. High
3. Wipe the dipstick clean with a clean cloth.
4. Insert the dipstick into the oil-fill tube, then
remove the dipstick.
5. Read the oil level on the dipstick
•
If the oil level on the dipstick is too low
(Figure 13), carefully pour a small amount
of SAE 30 or SAE 10W-30 detergent oil into
the oil-fill tube, wait 3 minutes, and repeat
steps 3 through
is at the correct level. For the oil type, refer
to Changing the Engine Oil (page
•
If the oil level on the dipstick is too high
(Figure 13), drain the excess oil until the oil
on the dipstick is at the correct level; refer to
Changing the Engine Oil (page
Important:
If the oil level in the engine is too
low or too high and you run the engine, you
may damage the engine.
6. Install the dipstick into the oil-fill tube securely.
(Figure
3. Low
(Figure 13).
5 until the oil on the dipstick
20).
20).
13).
g193261