Publicité
Les langues disponibles
Les langues disponibles
Installation Steps
Insert visor into window channel, rear flange first. Insert rear flange between rubber trim and door post. Insert
front flange between the rubber door trim and the metal door frame. The top flange slides into the window channel.
mirror cap
metal
rubber door trim
door frame
3
Remove tape liner by pulling on free ends. Raise
window slowly and leave up for 24 hours to secure
visor to window channel.
4
Care and Cleaning
• Wash only with mild soap & dry with a clean cloth.
Congratulations!
You have purchased one of the many quality Auto Ventshade™ branded products offered by Lund International, Inc. We take the utmost
pride in our products and want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your
product is top quality in terms of fit, durability, finish and ease of installation.
™
Auto Ventshade
NOTE: Actual application may vary slightly from illustrations.
Repeat steps 1 thru 5 for passenger side
Lund International, Ventshade Accessories Division
655 Raco Drive, Lawrenceville, GA 30045
800-241-7219 • Fax 770-339-5839 • Visit us at lundinternational.com
© 2011 Lund International, Inc. All rights reserved.
, the Auto Ventshade
logo and the AVS
TM
TM
4 Piece Set
5
logo are trademarks of Lund International, Inc.
TM
Page 2 of 2
Install the rear visors using the same
preparation and installation methods
as the front visor. Note that front & rear
flange fit between the rubber & post.
Publicité
