Electrolux ESF 43020 Notice D'utilisation page 29

2. Adjust the water hardness setting to the
highest level.
3. Do a washing programme without
dishes.
Setting and starting a washing programme
Do these steps to set and start a washing
programme:
1. Close the door.
2. Turn the programme knob to set the
washing programme. Refer to the chap-
ter 'Washing programmes'.
– The on/off indicator light comes on.
– The phase indicator light or lights for
the washing programme start to flash.
3. Press the start/cancel button.
– The washing programme starts auto-
matically.
– The start/cancel indicator light comes
on.
– When the programme starts, only the
indicator light of the phase in progress
stays on.
When the washing programme oper-
ates, you cannot change the pro-
gramme. Cancel the washing pro-
gramme.
Warning! Only interrupt or cancel a
washing programme if necessary.
Caution! Open the door carefully. Hot
steam can come free.
Interrupting a washing programme
Open the door.
• The programme stops.
Close the door.
• The programme continues from the point
of interruption.
Cancelling a washing programme
Press and hold the start/cancel button until
the start/cancel indicator light goes off and
the phase indicator lights start to flash.
The washing programme is cancelled.
• At this time you can do these steps:
1. Switch off the appliance.
2. Set a new washing programme.
Fill the detergent dispenser with detergent
before you set a new washing programme.
All manuals and user guides at all-guides.com
4. Adjust the water softener to the water
5. Adjust the rinse aid dosage.
Setting and starting a washing
programme with delay start
1. Set a washing programme.
2. Press the delay start button.
3. Press the start/cancel button.
When the countdown is completed, the
washing programme automatically starts.
• The delay start indicator light goes off.
• The indicator light of the phase in progress
Cancelling a delay start:
1. Press and hold the start/cancel button
2. Press the start/cancel button to start the
End of the washing programme
• The appliance stops automatically.
• The end-of-programme indicator light
1. Switch off the appliance.
2. Open the door.
3. For better drying results, keep the door
Let the dishes cool down before you remove
them from the appliance. Hot dishes are
easily damaged.
Removing the load
• First remove items from the lower basket,
hardness in your area.
– The delay start indicator light comes
on.
– The countdown of the delay start
starts.
– The phase indicator lights go off.
comes on.
Do not open the door during the count-
down to prevent interruption of the
countdown. When you close the door
again, the countdown continues from
the point of interruption.
until, the start/cancel indicator light and
delay start indicator light go off. The
phase indicator lights start to flash.
washing programme.
comes on.
ajar for some minutes before you remove
the dishes.
then from the upper basket.
electrolux 29