Publicité
Les langues disponibles
Les langues disponibles
24 electrolux
5. Close the door.
Electronic adjustment
The water softener is set at the factory
at level 5.
1. Press and hold the start/cancel button.
Turn the programme knob clockwise until
the programme marker agrees with the
first washing programme on the control
panel.
Use of dishwasher salt
Caution! Only use dishwashers salt.
Types of salt that are not applicable for
dishwashers cause damage to the water
softener.
Caution! Grains of salt and salty water
on the bottom of the appliance can
cause corrosion. Fill the appliance with
salt before you start a washing
programme to prevent corrosion.
Do these steps to fill the salt container:
1. Turn the cap anticlockwise to open the
salt container.
2. Fill the salt container with 1 litre of water
(only the first operation).
3. Use the funnel to fill the salt container with
salt.
Use of rinse aid
Caution! Only use branded rinse aid for
dishwashers.
All manuals and user guides at all-guides.com
2. Release the start/cancel button when the
3. Press the start/cancel button one time to
4. Turn the programme knob to the off po-
4. Remove the salt around the opening of
5. Turn the cap clockwise to close the salt
When you set electronically the water soft-
ener to level 1, the salt indicator light does
not stay on.
on/off indicator light and the start/cancel
indicator light start to flash.
– At the same time, the end-of-pro-
gramme indicator light flashes to show
the level of the water softener.
Example:
5 flashes, pause, 5 flashes, pause, etc.
= level 5
increase the water softener level by one
step.
The end-of-programme indicator light
shows the new level.
sition to save the operation.
the salt container.
container.
It is normal that water overflows from the
salt container when you fill it with salt.
Do not fill the rinse aid dispenser with
other products (e.g. dishwasher clean-
Publicité
