OSOTEK Horizon H200 Mode D'emploi page 14

Cleaning the Dirty Water Tank
1. Press the dirty water tank release button, while pulling the tank out.
2. Hold the bottom of the dirty water tank, while pressing the button on the top of the dirty
water tank. Take out the solid waste bin upward, and empty the solid waste and dirty water
respectively.
3. Rinse the dirty water tank and solid waste bin with tap water.
Notes:
• Use the cleaning tool for assist.
• Clean the full tank sensor frequently to avoid adhesive stains from affecting its detection
accuracy.
Solid Waste Bin
Full tank sensor
Dirty Water Tank
4. Install the solid waste bin, then re-install the dirty water tank onto the main unit until you hear a
"click", which indicates it is installed in place.
13
Click