OSOTEK Horizon H200 Mode D'emploi page 10

Buttons
Self-cleaning Button:
Press to enable or disable the self-cleaning.
Mode Button:
Press to switch mode during cleaning.
Power Button:
Press to turn on/off the vacuum.
Voice Control Button:
1. Short press this button to turn on/off
the voice alerts or adjust the volume:
Press this button to switch from voice
alerts on (default) - low volume - voice
alerts off cyclically;
2. Press & hold, and then short press this
button to change the language:
Press and hold this button for 3s to
broadcast voice alerts in the current
language, that is, enabling the
language switch. Then, if no operations
are performed within 5s, the current
language will be still used; If you press
the voice control button within 5s, the
language will be switched to the next
one. If you perform no operation within
5s after that, the switched language
will be used, and so on.
LED Screen
Turbo Mode
Auto Mode
Dirty Water
Tank Full
Insufficient
Water in the
Clean Water
Tank
The Dirtiness/Error Indicator indicates the following information:
• Floor dirt detection
Blue (always on) – clean
Red (always on) – dirty
• Error status
Red (flashing 5s then stay on) – Fault
For detailed troubleshooting solutions, refer to Page 18 of the User Manual.
9
Dirtiness/Error
Indicator
Suction
Mode
Self-cleaning
Mode
Battery Level
Indicator
Tangled Roller
Brushbar
Common Error