OSOTEK Horizon H200 Mode D'emploi page 12

Switching Modes
Press to switch from Auto Mode, Turbo Mode, to Suction Mode.
" " Auto Mode
Daily stains cleaning Stubborn stains cleaning
CAUTION:
Do not rotate the vacuum from side to side while lying it down for cleaning to prevent the floor
brush from tilting up or dirty water from running out.
" "Turbo Mode " " Suction Mode
Water stains cleaning (do not
suck up dust)
Stop Cleaning/OFF
Hold the vacuum in the upright position to pause cleaning, or press the button
vacuum. To avoid dirty water residues, the vacuum will continue running for a few seconds before
turning off. Place the vacuum back onto the self-cleaning charging dock after it completely stops
working.
When the vacuum is paused in the upright position or turned off, pull the handle backward, and
push the vacuum to the self-cleaning charging dock with the help of wheels. Then you can use the
dock for storage, charging, and self-cleaning.
Notes:
• Put the vacuum back onto the self-cleaning charging dock properly after using it to prevent the
vacuum from tipping over due to improper placement.
• To prevent dirty water from flowing out, do not vertically uplift the whole main unit (as shown
in the figure below).
11
to turn off the