Getting Started; Setting The Clock; Connecting An Ipod/Usb Device; Preparing A Bluetooth Device - Sony XSP-N1BT Mode D'emploi

Masquer les pouces Voir aussi pour XSP-N1BT:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Getting Started

Setting the Clock

1
Press and hold MENU.
2
Press / to select [GENERAL], then
press ENTER.
3
Press / to select [CLOCK-ADJ], then
press ENTER.
The hour indication flashes.
4
Press / to set the hour and minute.
To move the digital indication, press /.
5
After setting the minute, press ENTER.
The setup is complete and the clock starts.
To display the clock, press DSPL.

Connecting an iPod/USB Device

1
Turn down the volume on the unit.
2
Connect the iPod/USB device to the unit.
A device with a Micro USB connector other than
iPod/iPhone can be connected/charged via the
supplied USB cable. For iPod/iPhone, use a USB
connection cable for iPod (not supplied).
Note
It is extremely dangerous if the USB cable becomes
wound around the steering column or gearstick. To
prevent this, store the USB cable in the main unit.
For details on placing a smartphone on the unit, see
page 9.

Preparing a BLUETOOTH Device

You can enjoy music, or perform handsfree calling,
by connecting a suitable BLUETOOTH device. For
details on connecting, refer to the operating
instructions supplied with the device.
Before connecting the device, turn down the
volume of this unit; otherwise, loud sound may
result.
Pairing and connecting with a
BLUETOOTH device
When connecting a BLUETOOTH device (cellular
phone, audio device, etc.) for the first time, mutual
registration (called "pairing") is required. Pairing
enables this unit and other devices to recognize
each other.
1
Place the BLUETOOTH device within 1 m
(3 ft) of this unit.
2
Press CALL.
3
Press / to select [PAIRING], then press
ENTER.
flashes.
The unit enters pairing standby mode.
4
Perform pairing on the BLUETOOTH
device so it detects this unit.
5
Select [Sony Car Audio] shown in the
display of the BLUETOOTH device.
If [Sony Car Audio] does not appear, repeat from
step 2.
6
If passkey* input is required on the
BLUETOOTH device, input [0000].
* Passkey may be called "Passcode," "PIN code,"
"PIN number" or "Password," etc., depending on
the device.
7
GB

Publicité

Table des Matières
loading

Table des Matières