Ribimex PRBAT20 Manuel D'instructions Et D'utilisation page 21

4.6.1- Blade
1. Pull the locking tab all the way out (Fig. 6).
2. Position the cutting blade or scraper on the support (position the blade so that the elbow faces
downwards).
Note: You can adjust the blade orientation to the desired working position, aligning the holes on the
soleplate with the lugs on the bracket.
3. Close the locking tab (Fig. 8).
To remove the blade: Follow the steps above in reverse order.
4.6.2- Other accessories (not supplied (*))
(*) Other accessories such as: half-moon saw blade ...
1. Pull the locking tab all the way out (Fig. 6).
2. Position the accessory on the support.
Note: You can adjust the orientation of the accessory to the desired working position, aligning the
holes on the soleplate with the lugs on the support.
3. Close the locking tab (Fig. 8).
To remove the accessory: Follow the steps above in reverse order.
4.7- Switching On and Off
Only use original Rbat lithium-ion batteries with the voltage indicated on the
product nameplate. Using other batteries may cause malfunctions, damage to the
product, injuries and fire hazards.
1. Insert the charged battery until you feel it snap and aligned with the handle.
2. To start the machine, push the on / off switch forward so that the I appears on the switch.
3. To turn off the machine, pull the on / off switch backwards so that the O appears on the switch.
4.8- Preselection of orbital stroke rate
With the orbital stroke preselection dial, you can preselect the required orbital velocity even during
operation. The required typing speed depends on the material and working conditions and can be
determined by practical tests.
V. OPERATION
5.1- Intended use
The tool is intended for household use.
The machine is intended for:
- dry sawing or dry cutting wooden materials, plastic, gypsum, non-ferrous metals, soft wall
tiles and fastening elements (e. g., unhardened nails, staples), within the tool specified limits.
- dry sanding and scraping of small surfaces, within its specified limits
- This tool should not be used to do other things than the uses described in this manual.
- Do not use the tool for improper purposes (eg working on products containing hazardous or harmful
materials...).
- The tool is not designed for professional and / or industrial use.
All manuals and user guides at all-guides.com
Fig. 6 Fig. 7 Fig. 8
Page 21 / 34