Publicité
Les langues disponibles
Les langues disponibles
2013-05-01
h
Connect the voltage supply, all segments are lit permanently for 5s (segment test).
When all connections on the device are carried out correctly, it displays the current temperature on analog input 1.
If an alarm or error message appears, refer to Chapter 8 „Error messages".
4.2 Actual value display (after switch-on or timeout)
Parameter di.P is used to set the actual value to be displayed.
v
Chapter 5.8 „LC display"
If the
or
keys are used to change the actual value, the devices automatically switches back after a timeout.
4.3 Change-over to the parameter level (code inhibit)
The device parameters are factory-set in the parameter level and inhibited via a code.
All parameters can be edited within the value range as described in the following table.
h
Press the
key for 3 seconds and
h
Use the
and
keys to set the code for the parameter level
(factory-set code 72).
The longer the key is kept pressed, the faster the value changes.
h
Use
to acknowledge
The first Parameter and Value appear alternately
4.4 Selecting and editing parameters (navigation principle)
h
Use the
and
keys to select all parameters (to the top or bottom within the parameter table).
All manuals and user guides at all-guides.com
4 Commissioning/starting up the device
appears alternately.
.
10
Publicité
