Publicité
Les langues disponibles
Les langues disponibles
5.1.3 Controlling the LED intensity (lights) ➀.
Place the key near the circle.
Flashing blue light.
Press on the button until the LEDs
and
Both LEDs (lights) flash.
6.1 Signal characteristics for external command
Control the thermostat using a
programming base unit able to
issue the instructions given in
the table below.
Connect the base unit to the
thermostat using a pilot wire.
Check that the command
signal corresponds to the
desired operating mode.
7.1 Caractéristiques
techniques du
thermostat
28
CLASSIC
®
ELECTRONIC THERMOSTATS
User instructions
start flashing.
Mode
COMFORT
ECONOMY
ECONOMY 1
ECONOMY 2
FROST-PROTECTION
OFF
Power supply
Heating power
Insulation category
Protection category
Shock resistance
Operating temperature
Storage temperature
Operating humidity levels
Temperature control
Temperature selection range
Maximum error I selected temperature
NF (French Norms) Performance Category C
Set the desired intensity using the
knob on button
Move the key away.
The blue light stops flashing.
The LED intensity has been set.
Turn the knob once again to set the
temperature to the desired level.
The lights ➀ now come on at the
desired intensity.
Command description
No signal
Alternating
No current for 5 minutes.
Alternating for 3 seconds.
No current for 5 minutes.
Alternating for 7 seconds.
Negative half-wave
Positive half-wave
230 V 50 Hz
2000 W maximum
II
IP24
IK10
0 ÷ 50°C
-20÷80°C
20÷95% without any condensation
Analogical using a knob
7 ÷ 30°C
0.5°C
➁
.
Signal
Publicité
