KALIREL Cyclope Notice D'emploi page 24

3.1.3 Connecting to the external command
for load shedding
Use the pilot wire. Connect the electric wire to
the programming base unit fitted with a pilot
wire.
If the pilot wire is not connected to a
!
programming base unit then it must be
insulated for safety reasons. In no event
should it be connected to the earth.
4.1 Use
4.1.1 Operating characteristics
The operating characteristics are:
- Controlling the temperature.
- Selecting and controlling the operating mode.
4.1.2 Controlling the temperature
22
Turn the knob until you
-
obtain the required temperature.
24
4.1.3 Selecting and controlling
the operating mode
Press button and release it to select and
3
control the desired operating mode.
The operating mode changes with each brief push
of the button. The selected mode is indicated
by status light .
1
AUTOMATIC COMFORT
CYCLOPE ®
ELECTRONIC THERMOSTATS
User instructions
ECONOMY FROST-PROTECTION
AUTOMATIC MODE
The operating mode is controlled by
Blue light on
the signal emitted by the Cyclope
radio control. The selected mode is
indicated by the status light.
COMFORT MODE
The normal comfort operating mode
Red light on
is on. The temperature is that dialled
by knob ➁.
ECONOMY MODE
The night-time economy mode is on.
Green light on
The temperature is automatically 3.5°C
lower than that of the comfort mode.
FROST–PROTECTION MODE
Flashing green The frost-protection mode is on.
light
The temperature is set at 7°C.
This minimal temperature means
material runs no risk of freezing up.
4.1.4 Identifying malfunctions
HEATING ELEMENT
The heating element is operating
Red light on
normally.
Flashing red light
There is a problem with the
thermostat.
4.1.5 Turning the thermostat off
Hold down button
then release it. The thermostat
stops.
To turn the thermostat on again
press button
®
3
for 5 seconds
briefly
3
23