DeWalt XR DCS575 Traduction De La Notice D'instructions Originale page 52

EnGLISH
See Technical Data for charging time.
Do not probe with conductive objects.
Do not charge damaged battery packs.
Do not expose to water.
Have defective cords replaced immediately.
Charge only between 4 ˚C and 40 ˚C.
Only for indoor use.
Discard the battery pack with due care for
the environment.
Charge D WALT battery packs only with designated
e
D WALT chargers. Charging battery packs other than
e
the designated D WALT batteries with a D
e
charger may make them burst or lead to other
dangerous situations.
Do not incinerate the battery pack.
USE (without transport cap). Example: Wh rating
indicates 108 Wh (1 battery with 108 Wh).
TRANSPORT (with built-in transport cap). Example:
Wh rating indicates 3 x 36 Wh (3 batteries of 36 Wh).
Battery Type
The DCS575 and DCS576 operate on a 54 volt battery pack.
These battery packs may be used: DCB546, DCB547, DCB548.
Refer to Technical Data for more information.
Package Contents
The package contains:
1 Circular saw
1 Circular saw blade
1 Blade wrench
1 Parallel fence
1 Dust extraction port
1 Charger (T models only)
1 Li-Ion battery pack (T1 model)
2 Li-Ion battery packs (T2 model)
3 Li-Ion battery packs (T3 model)
1 Instruction manual
nOTE: Battery packs, chargers and kitboxes are not included
with N models. Battery packs and chargers are not included with
NT models. B models include Bluetooth® battery packs.
50
All manuals and user guides at all-guides.com
WALT
e
nOTE: The Bluetooth® word mark and logos are registered
trademarks owned by the Bluetooth®, SIG, Inc. and any use of
such marks by D WALT is under license. Other trademarks and
e
trade names are those of their respective owners.
• Check for damage to the tool, parts or accessories which may
have occurred during transport.
• Take the time to thoroughly read and understand this manual
prior to operation.
Markings on Tool
The following pictograms are shown on the tool:
Read instruction manual before use.
Wear ear protection.
Wear eye protection.
Visible radiation. Do not stare into light.
Date Code Position (Fig. H)
The date code 18 , which also includes the year of manufacture,
is printed into the housing.
Example:
2019 XX XX
Year of Manufacture
Description (Fig. A, H)

WARNING: Never modify the power tool or any part of it.
Damage or personal injury could result.
Trigger switch
1
Trigger switch lock-off button
2
Main handle
3
Rafter hook (Included with some models)
4
Blade lock
5
End cap
6
Auxiliary handle
7
Bevel adjustment lever
8
Bevel angle adjustment mechanism
9
LED worklight
10
Base plate
11
Lower blade guard
12
Blade clamping screw
13
Lower guard lever
14
Upper blade guard
15
Battery pack
16
Battery release button
17
Date code (Fig. H)
18
Rail adjuster (0° cutting)
19
Rail adjuster (1–45° bevel cutting)
20
Fuel gauge button (on battery pack)
21