Connecting Charger To Power Supply; Charging The Battery - Stihl Rma 370 Notice D'emploi

Setting the cutting height
2
1
3
Push the height adjustment
N
lever (1) slightly away from the
cordless lawn mower until the snap
fittings (2) release the lever.
Greater cutting height:
Lift the cordless lawn mower with
N
the height adjustment lever (1) – the
lever is pushed forwards
Smaller cutting height:
Push the cordless lawn mower
N
down with the height adjustment
lever (1) – the lever is pushed
backwards
Push the height adjustment
N
lever (1) towards the cordless lawn
mower until the snap fittings (2)
engage in the lever.
The selected cutting height is shown on
the front snap fitting (3).
RMA 370
All manuals and user guides at all-guides.com
Connecting Charger to
Power Supply
Power supply (mains) voltage and
operating voltage must be the same.
Insert the plug (1) in the wall
N
outlet (2).
1
A self test is performed after the charger
is connected to the power supply. During
this process, the light emitting diode (1)
on the charger lights up green for about
1 second, then red and goes off again.

Charging the Battery

A factory-new battery is not fully
charged.
Recommendation: Fully charge the
battery before using it for the first time.
2
Connect the charger to the power
1 N
supply – mains voltage and
operating voltage of the charger
must be the same – see
"Connecting Charger to Power
Supply".
Operate the charger only in enclosed
and dry rooms at ambient temperatures
between +5°C to +40°C (+41°F to
+104°F)
Only charge dry batteries. Allow a damp
battery to dry before charging.
Push the battery (1) into the
N
charger (2) until noticeable
resistance is felt – then push it as far
as stop.
English
2
11