Sencotel Granitore 1 Mode D'emploi page 46

Fig.44
Periodically clean the condenser situated inside the machine.
faces of the machine.
To access the condenser remove the safety guards.
The safety guards must be removed by means of a suitable screwdriver.
Fig.45
Remove the rear guard after taking out the screws securing it to the frame (the
screws are positioned on the left and right sides).
After removing the guard, use a dry brush to remove the dust that has built up
over time with use.
- 18 _EN-
Fig.46
Once the condenser has been thoroughly cleaned, t all the safety guards back
in position.
7.9.2.
-
-
To remove the safety guard panel, proceed as follows:
- Lift and completely remove the upper part of the side guard;
- Unscrew the 4 screws securing the guard in place;
-
Fig.47
Fig.48
- After removing the 4 screws, take off the guard.
After removing the guard, use a dry brush to remove the dust that has built up
over time with use.
SL310006569 Ed.01 - 03-2014