Sencotel Granitore 1 Mode D'emploi page 42

"O", and empty the bowl of all its contents.
After that, put off both the main switch and mixer switch
chine. chine
Fig.27
Before removing the bowl it is recommended to disassemble the tap; after
cleaning the tap must not be reapplied until the bowl has been correctly posi-
tioned in its seat.
Disassemble the tap and remove the pin
other parts.
Fig.28
These components may be placed in a basin containing hot water (approx.
50°C); they must later be treated as described in section 7.4.
- 14 _EN-
-
from its seat to release all the
Fig.29
7.3.
Removal of every machine bowl is fundamental to ensure correct machine
cleaning and sanitization.
To remove a bowl correctly proceed as follows:
1 remove the lid as shown at paragraph 6.1.
Fig.30
2 raise the front part of the bowl to release it;
3 remove the bowl from its seat by pushing and tapping lightly on the rear part;
Fig.31
4 take out the auger and remove the seals (A and B).
WATER
SL310006569 Ed.01 - 03-2014