Electrical Connection - Sencotel Granitore 1 Mode D'emploi

Fig. 5 shows the clearances required for access:
the control panel on the right side;
machine parts so that they may be serviced in the event of a fault.
After positioning the packing container in the vicinity of the installation site, pro-
ceed as follows:
1. cut the straps securing the box;
2. lift the cardboard box;
3. then lift the machine and position it on the prepared site.
relevant section herein.
After opening the box, make sure to separate the packing materials according
to type and dispose of them in accordance with the current regulations in the
user's country.
We recommend keeping the box for future conveyance or transport

5.4. Electrical connection

sonnel.
Before plugging in the machine, make sure that the main switch is on "0".
The Purchaser is responsible for making the electrical connection.
The machine must be connected to the electricity mains by means of the plug
tted on the power cord. Be sure to comply with:
the technical regulations and standards in force at the time of installation;
the data shown on the rating plate on the side of the machine.
sary.
It is forbidden:
- 8 _EN-
6. OPERATION
-
NEVER USE ONLY WATER
Fig.6
Dilute and mix the CONCENTRATE with WATER in a suitable container, follow-
ing the manufacturer's directions. THE MIXTURE OBTAINED MUST HAVE A
-
MINIMUM SUGAR CONTENT OF 13° BRIX - A lower concentration may dam-
age the augers and/or gearmotors.
To remove the lid from the bowl, follow these instructions:
1 lift the rear part of the lid;
2 extract the lid from the retainer placed in the front side.
-
Fig.7
SL310006569 Ed.01 - 03-2014
-