Sencotel Granitore 1 Mode D'emploi page 43

Fig.32
All of the previously disassembled and removed components must be thor-
oughly washed and sanitized.
tions in force at the time the machine is used.
To carry out the procedure correctly, please use the following instructions:
1 Fill a container with a sanitizer solution mixed in water (2% of sodium hy-
poclorite mixed in water)
2. Thoroughly wash the tank, lid and evaporator with a sponge soaked in the
sanitizer solution
3 Thoroughly wash again with clean water
4 Fill another container with a sanitizer solution
5 Dip the dismantled components into the sanitizer solution
6 Leave the dismantled components to soak in the solution for 30 minutes
7 Thoroughly wash again with clean water
8 Place the components on a clean surface and dry them
9 Assemble the machine as described in part 7.5
10 Before using the machine again carry out the rinsing cycle with clean water
( part 7.6 ).
To clean the lighted lid correctly, proceed as follows;
1. Using a clean, damp cloth, rst wipe clean the bottom part of the lid (in con-
tact with the product);
2. Using a clean, damp cloth, wipe clean the whole outer part;
Outer part
Fig.33
Bottom part
SL310006569 Ed.01 - 03-2014
3. Using a sponge dipped in sanitising solution, sanitise the bottom part of the
lid, taking care not to wet the contacts (X);
4. Allow to act for 30 minutes;
5. Rinse twice or more, only the bottom part, with a clean sponge soaked in
fresh water.
6. Place the lid on a clean surface and dry it; rst dry the bottom and then the
outer part by means of a clean cloth.
7. Set the lid back in place only after having cleaned and sanitised the bowl.
in the machine.
All of the washed and sanitized components must be carefully reassembled.
Some components must be adequately lubricated in order to ensure that they
-
work ef ciently.
Apply the seal on the auger as shown in the g.34.
Fig.34
-
Using the Vaseline provided, lubricate the seal
g.35.
Fig.35
in the areas shown in the
- 15 _EN-