Sencotel Granitore 1 Mode D'emploi page 44

Apply seal , lubricating the entire surface indicated by the arrows with Vase-
line.
Fig.36
Introduce the auger, engaging head
Fig.37
Set the bowl back in place; slightly raise head
the seat provided in the bowl.
Fig.38
- 16 _EN-
with shaft .
of the auger so that it meets
Press the bowl downward until it engages the surface as shown in the gure.
Fig.39
Follow these instructions to re t the tap:
1 using the vaseline provided, adequately lubricate the cap
components;
2 introduce the pin while keeping the tap lever steady.
Fig.40
Before starting up the machine, you must carry out the rinsing cycle.
Proceed as follows:
1 ll the tank with clean water
2 let the machine on for 5 minutes in the "agitation" mode only
3 turn off the machine and empty the tank by opening the tap
, and re t the
SL310006569 Ed.01 - 03-2014