dosatron SD25AL5 Manuel D'utilisation page 48

PULSE WATER
METER CONNECTION
1
- Connect the water meter to the doser inlet.
Ensure that the water flows in the direction of the meter arrow.
2a
- Unclip the water meter lid.
2b
- Position the tightening screw to the "0" position.
3
- Position the IZAR PULSE
Click into place by pressing the ring on the module, manually only.
4
- Place the water meter lid on the IZAR PULSE
5
- Reposition the IZAR PULSE pulse transmitter tightening screw
SUCTION PIPE TO LEVEL
DETECTION PIPE CONNECTION
1
- Connect the suction pipe.
2
- Lock the tightening screw.
3
- Connect the level detection pipe to the monitoring module.
N.B. Never shorten the level detection pipe.
Adjust the length of the suction pipe (large diameter) on the basis of your treatments tank.
pulse transmitter by aligning the lid hinges up to each other.
®
®
4
3
5
1
2
© ©
DOSATRON INTERNATIONAL S.A.S. / 12 DOSATRON INTERNATIONAL S.A.S. / 48
pulse transmitter.
to "1".
®
2
a
2
b
1
3